Re: PLIP on 11r6

From: Bob Romprey ([email protected])
Date: Fri Feb 09 2001 - 04:44:12 CET

('binary' encoding is not supported, stored as-is) Michele,
I don't know if this is of any help, but when installing a modem under windoze the option to use LPT1 as the "port" for the modem is there.
Think I'll look at that because a LP port will send/receive data at much better rates than a serial port(8 data lines???)

>Reply-To: [email protected]
>Date: Thu, 8 Feb 2001 13:53:41 +0100
>From: Michele Andreoli <[email protected]>
>To: [email protected]
>Subject: Re: PLIP on 11r6
>
>On Wed, Feb 07, 2001 at 06:58:02PM +0000, Ben Wheare nicely wrote:
>> Hi,
>> How do I set up PLIP so it will connect over LPT1 to my Win98 machine?
>>
>
>Never tried. I do not know if win98 support TCP/IP over parallel cable.
>I always used two Linuxes.
>
>Michele
>--
>In summing up, I wish I had some kind of affirmative message to leave
>you with, I don't. Would you take two negative messages? - Woody Allen
>
>---------------------------------------------------------------------
>To unsubscribe, e-mail: [email protected]
>For additional commands, e-mail: [email protected]

------------------------------------------------------------
Visit the world's greatest site at http://www.farts.com and listen to the fart
of the day. Also, get your very own farts.com E-mail account. FREE!!!!!

---------------------------------------------------------------------
To unsubscribe, e-mail: [email protected]
For additional commands, e-mail: [email protected]

This archive was generated by hypermail 2.1.6 : Sat Feb 08 2003 - 15:27:18 CET