From: NINAD BAPAT -WOR ([email protected])
Date: Wed Jun 06 2001 - 09:33:00 CEST
Hi
I have successfully installed MU11R12 on my home PC.
My office has about 20 PC's connected with LAN. The Pc's are all branded IBM
pcs. The pc's in my deptt are quite new ones (bought 1 year back).
The config of my Office Pc is
Pentium 465, 8G HDD, 1.44FDD in-built sound card Win98 Os
I am tryin to install MU10R5 and am not able to do the same.
After unpacking when I boot from pure DOS mode It gives all the standard
messages and after
'hda: hda1 the following error message is generated and the systems halts.
General protection fault 0000
Cpu 0
And a long list of memory addresses stackpage:and registers etc.
I have tried installing it all the ways possible.
* Safe mode command prompt (i.e.without any Windows drivers)
* Pure DOS command prompt with the startup files i.e Autoexec.bat
If I boot through the boot diskette I can clone it on my HDD but cannot
boot.
The system stops after mounting hda1
There is no alternative but to reboot. This happens only on the new
computers.
Can someone help
Thanks and Regards
Ninad Bapat
Email : [email protected]
---------------------------------------------------------------------
To unsubscribe, e-mail: [email protected]
For additional commands, e-mail: [email protected]
This archive was generated by hypermail 2.1.6 : Sat Feb 08 2003 - 15:27:19 CET