Re: [mu SETUP] Error: Cannot open initial console

From: Michele Andreoli ([email protected])
Date: Thu Jun 28 2001 - 22:40:01 CEST


On Thu, Jun 28, 2001 at 02:43:07PM -0400, Matthew Miller nicely wrote:
> Hi,
>
> Im trying to start mulinux after unpacking and following the directions. I execute boot.bat and the system is fine up until the hard drive section before mounting the file system. Immediately at the point where it mounts the filesystem, it reports: Cannot open initial console.
>
> Here are the facts:
> 1.) I'm using the current stable version of mulinux
> 2.) I'm booting from the hard drive in dos mode
> 3.) I have a loadlin line pointing to root=/dev/hda1 (which is correct)
> 4.) mu linux is in the C:\mulinux directory

It seems all correct. Did you see a c:\linux directory in this disk?

>
> --Other--
> 1.) I tried using /dev/mem instead of /dev/hda1, but I get a kernel panic when I do that.

Oh, no. /dev/mem isn't an hard-disk, as you might expect by the name.
You can know the list of partition with:

                -- maintenance mode --
                # fdisk -l

Michele

-- 
I keep trying to locate a meeting of Quantum Physicists. But everytime
they set a meeting time, the location changes. And vice versa -- Anonymous
---------------------------------------------------------------------
To unsubscribe, e-mail: [email protected]
For additional commands, e-mail: [email protected]


This archive was generated by hypermail 2.1.6 : Sat Feb 08 2003 - 15:27:19 CET