From: Trevor Sansom ([email protected])
Date: Wed Jul 25 2001 - 23:34:26 CEST
--- Hakapeszi Maki <[email protected]> wrote: >
>
> Hi!
>
> I've installed MuLINUX 12.0 on the HDD of a laptop
> with a 486 and 4 MB RAM (Compaq Contura 4/25). It
> works well, but of course it is very slow. I tried
> to help it with using just 3 consoles, bigger (32
> MB) swap and minimal addons (X11 and TEX, which I
> need), but it couldn't help much. Do anybody have
> more ideas?
> My other problem is, that at booting I have to wait
> long minutes for setup. Of course I have to see a
> lot of Setting up ...: unwanted /skiped. What can I
> do, if I want MuLinux not to look for these
> components at booting? (I know that the most of them
> I will need never on that machine.)
>
> Thank You for Your help!
>
> --
>
> Hakapeszi
> Jobb a sörhas, mint a pizzahát!
>
---------------------------------------------------------------------
> I can't really help with your problem but perhaps
you can help with mine. I have the same laptop as you
and have installed Caldsera Open Linux, with some
difficulty using Win95 & a laplink cable. I'd like to
have the whole machine for Linux but need Win95 for
the laplink connection. I tried looking at mulinux but
it didn't seem too easy for a newbie to install, can
you offer any advice, please.
Trevor Sansom
____________________________________________________________
Do You Yahoo!?
Get your free @yahoo.co.uk address at http://mail.yahoo.co.uk
or your free @yahoo.ie address at http://mail.yahoo.ie
---------------------------------------------------------------------
To unsubscribe, e-mail: [email protected]
For additional commands, e-mail: [email protected]
This archive was generated by hypermail 2.1.6 : Sat Feb 08 2003 - 15:27:19 CET