[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: [usb] usb clarifications
Hello ravi,
Gothrough the lines within codes,it is taken from the usb
specification 1.1 in the page 231.
"In the downstream direction, hubs operate in a broadcast
mode. When a hub detects an SOP on its
upstream port, it establishes connectivity to all enabled
downstream ports. If a port is not enabled, it does
not propagate packet signaling downstream."
With regards
Senthil
On Fri, 14 Jun 2002 Ravi Kumar wrote :
>hi all,
>In USB .
>Consider the OUT transaction ,
>will the host controller
>sends the data to all the devices in broadcast or
>will it select particular hub where the devices is
>anchored & send the data to that particular hub .
>
>Pls reply
>Regards
>Ravikumar
>
>
>
>
> --- [email protected] wrote: > Hi,
> >
> > During an enumeration process, what should be the
> > address value in
> > the Setup Token. Is it always "zero" or the
> > address value of the device
> > which is being sent in "Set Address" command in
> > the data phase?
> >
> > SetUp Token (Sync,Pid,Addr,Endp,crc5,Eop) ; Addr
> > = 0 / [1-128] ?
> > Data (Sync,Pid,Data0,crc16,Eop); //
> > Data0 has the command
> >
> > If I change the address of a device, what is the
> > address value in the
> > Setup Token. Is it zero or the old value?
> >
> > A quick reply is appreciated.
> >
> > Thanks
> > Govind
> > --
> > To unsubscribe from usb mailing list please visit
>http://www.opencores.org/mailinglists.shtml
>
>________________________________________________________________________
>Everything you always wanted to know about cars and bikes,now
> at: http://in.autos.yahoo.com
>--
>To unsubscribe from usb mailing list please visit
>http://www.opencores.org/mailinglists.shtml
_________________________________________________________
Click below to visit monsterindia.com and there is always a
better job for you at http://monsterindia.rediff.com/jobs
--
To unsubscribe from usb mailing list please visit http://www.opencores.org/mailinglists.shtml