[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: [usb] usb clarifications
hi all
I have a clarification on usb.
Would some tell me
1)what is the packet structure
for assigning an address to the device.
is the command is
set_addres
followed by a data phase for the address to be
assigned to device.
2)
do we assign a unique address to an endpoint of the
device or what ?
regards
Ravikumar
--- Vikas T Rao <[email protected]> wrote: >
** Proprietary **
>
> hi ravi,
>
> hub should recognise the device attachment and
> detachment. this will be indicated to the host by
> the status change endpoint mechanism if it is a hub,
> if hub acts as root hub then it will be reported in
> the port control and status register. i suggest you
> to go through the chapter-->11 refer 11.12 hub
> controller.
>
> ...vikas
>
>
> >>> [email protected] 06/17/02 09:45PM >>>
> hi all,
> I understand that usb host polls devices in frequent
> intervals for periodic kind of transfers (namely
> Isochronous & Interupt Transfer type) , but with
> what
> frequency that it polls the Hub's Status endpoint
> for
> detecting the attachment & Detachement of usb
> devices.
>
> I beleive the frequency that it polls the Hubs
> status
> Descriptor is relatively higher -- Would u pls
> clarify
> whether i have understood correctly
>
> Regards
> Ravikumar
>
>
>
>
>
> --- senthil nadesan
> <[email protected]>
> wrote: >
> > Hello ravi,
> > Gothrough the lines within codes,it is taken
> from
> > the usb
> > specification 1.1 in the page 231.
> >
> > "In the downstream direction, hubs
> operate
> > in a broadcast
> > mode. When a hub detects an SOP on its
> > upstream port, it establishes connectivity to all
> > enabled
> > downstream ports. If a port is not enabled, it
> does
> > not propagate packet signaling downstream."
> >
> > With regards
> > Senthil
> >
> >
> > On Fri, 14 Jun 2002 Ravi Kumar wrote :
> > >hi all,
> > >In USB .
> > >Consider the OUT transaction ,
> > >will the host controller
> > >sends the data to all the devices in broadcast or
> > >will it select particular hub where the devices
> is
> > >anchored & send the data to that particular hub .
> > >
> > >Pls reply
> > >Regards
> > >Ravikumar
> > >
> > >
> > >
> > >
> > > --- [email protected] wrote: > Hi,
> > > >
> > > > During an enumeration process, what should
> be
> > the
> > > > address value in
> > > > the Setup Token. Is it always "zero" or the
> > > > address value of the device
> > > > which is being sent in "Set Address"
> command
> > in
> > > > the data phase?
> > > >
> > > > SetUp Token (Sync,Pid,Addr,Endp,crc5,Eop) ;
> > Addr
> > > > = 0 / [1-128] ?
> > > > Data (Sync,Pid,Data0,crc16,Eop);
>
> > //
> > > > Data0 has the command
> > > >
> > > > If I change the address of a device, what
> is
> > the
> > > > address value in the
> > > > Setup Token. Is it zero or the old value?
> > > >
> > > > A quick reply is appreciated.
> > > >
> > > > Thanks
> > > > Govind
> > > > --
> > > > To unsubscribe from usb mailing list please
> > visit
> > >http://www.opencores.org/mailinglists.shtml
> > >
> >
>
>________________________________________________________________________
> > >Everything you always wanted to know about cars
> and
> > bikes,now
> > > at: http://in.autos.yahoo.com
> > >--
> > >To unsubscribe from usb mailing list please visit
>
> > >http://www.opencores.org/mailinglists.shtml
> >
> >
>
_________________________________________________________
> > Click below to visit monsterindia.com and there is
> > always a
> > better job for you at
> > http://monsterindia.rediff.com/jobs
> >
> > --
> > To unsubscribe from usb mailing list please visit
> http://www.opencores.org/mailinglists.shtml
>
>
________________________________________________________________________
> Want to sell your car? advertise on Yahoo Autos
> Classifieds. It's Free!!
> visit http://in.autos.yahoo.com
> --
> To unsubscribe from usb mailing list please visit
> http://www.opencores.org/mailinglists.shtml
>
> --
> To unsubscribe from usb mailing list please visit
http://www.opencores.org/mailinglists.shtml
________________________________________________________________________
Want to sell your car? advertise on Yahoo Autos Classifieds. It's Free!!
visit http://in.autos.yahoo.com
--
To unsubscribe from usb mailing list please visit http://www.opencores.org/mailinglists.shtml