From: [email protected]
Date: Sat Jan 27 2001 - 11:04:46 CET
On Fri, 26 January 2001, "Bob Romprey" wrote:
>
> Did you specify
> ttyS0
> or
> /dev/ttyS0
> ???
> /dev/ttyS0 is actually the path to the location/name of the file that's used for "com1" under dos
> As linux treats devices as just another file to be read or written to, you must specify /dev/ttyS0 to tell configuration that your mouse is on com1 (dos)
> Hope this helps
>
> winsor
>
hmmmm.... n then do you know how to configure my logitech mouse ?? cause that problem always comes if i configure from "setup -f port"
thanks a lot...
ARNOLD
> >Reply-To: [email protected]
> >Date: 25 Jan 2001 23:42:05 -0800
> >To: [email protected]
> >From: [email protected]
> >Subject: ttyS0, ttyS1, ttyS2's problem
> >
> >dear all,
> >
> >I'm still not understand about this problem, when I was triying to configure port ( setup -f port ), then there was a problem like this :
> >
> >ttyS0 : no such device
> >ttyS1 : no such device
> >
> >thanks,
> >arnold
> >
> >
> >
> >---------------------------------------------------------------------
> >To unsubscribe, e-mail: [email protected]
> >For additional commands, e-mail: [email protected]
>
>
>
>
>
>
> ------------------------------------------------------------
> Visit the world's greatest site at http://www.farts.com and listen to the fart
> of the day. Also, get your very own farts.com E-mail account. FREE!!!!!
>
>
>
> ---------------------------------------------------------------------
> To unsubscribe, e-mail: [email protected]
> For additional commands, e-mail: [email protected]
---------------------------------------------------------------------
To unsubscribe, e-mail: [email protected]
For additional commands, e-mail: [email protected]
This archive was generated by hypermail 2.1.6 : Sat Feb 08 2003 - 15:27:18 CET